EU-049 ENGINE CLEANER FOAM

ENGINE CLEANER, Fast Acting Foam Spray quickly removes dirt, dust and road grime from cars, trucks, power motors, RV's, ATVs, bikes, farm equipment and tractors. Safe on most underhood rubber, plastic and paint when used as directed. DIRECTIONS FOR USE (Read the entire label before using): Do not start your engine after you applied product until entire engine is properly rinsed. Rinsing is necessary to properly clean engine and to avoid potential fire hazard. SAFEGUARD OUR ENVIRONMENT. USE THE MINIMUM AMOUNT OF RINSE WATER NECESSARY AND SEE DISPOSAL STATEMENT BELOW. 1. Engine must be off and cool. 2. Care must be taken with all underhood wiring and electronic sensors or components. Cover any open carburetor or intake system openings. Cover exposed electrical and electronic components (uncovered cracked, frayed wires or engine computer units can short circuit). 3. Shake well and apply generously to dry engine. Make sure to cover all dirty and grimy surface area with product. Rinse over spray from exterior body surfaces to avoid the possibility of dewaxing or streaking. Engine cleaners may cause spotting or damage custom paint or graphics. 4. Allow product to soak for 10 to 15 minutes. Brush unusually heavy deposits to break up dirt. 5. Rinse all areas with a fine stream of water from top down. Minimize rinse water in areas that can cause performance problems (electronics & intakes). 6. When finished, remove added coverings and replace any removed parts. Start your engine and idle for 15 minutes to assure complete drying.